![favicon_GI.png]](https://knowledge.gantner-instruments.com/hs-fs/hubfs/favicon_GI.png?width=40&height=40&name=favicon_GI.png){kind=small}
Data Acquisition Hardware
Helpful information for installing, configuring and using Gantner Instruments data acquisition hardware.
I/O modules
- Getting Started With Q.boost Modules
- How to Update the Firmware on a Module
- Arithmetic Functions at the Module Level: Standard vs. Signal Conditioning
- Switching Between LocalBus and EtherCAT Bus Communication
- Understanding Digital Filtering for Analog Inputs
- A146 lead wire resistance
- Q.staxx modules connection details
- Q.series X SV with Sensor Supply
- Q.bloxx Special Terminal Blocks
- Q.series Terminal Block Connections
- Configuring UART and Module Address Settings
- DIP switch settings for EtherCAT/XE modules
- Module Selection Guide - Sensors
- PNP and TTL/HTL Signal Handling in Digital Input Modules
- Carrier Frequency configuration and synchronisation
- Setting Special Parameters for I/O modules
- How to Connect Digital Outputs for Maximum Response Speed
Q.station & Q.monixx Controller
- UART Communication and Buffer Handling
- Controller Firmware Update Procedure for v2.12 or Earlier (Q.station only)
- FTP & SFTP Data Logging for Q.series DAQ Systems: Setup, File Transfer & Troubleshooting
- Sending Data Logger Files from a Q.station Controller via Email
- GPS Receiver Integration for Time and Position Synchronization
- Which serial converters and gateways can I use?
- Using VNC Viewer to Access the Controller’s Embedded HMI Panels
- Updating the Firmware on a Controller
- Q.station 101 Quick Start Guide
- Retrieve files from a USB flash drive
- Creating Arithmetic Functions on the Controller
- Data Logging to a PC or Network Attached Storage (NAS)
- Comparative Analysis: Q.monixx vs. Q.station X
- Reading serial data from a RS232/RS485 sensor
- Recommended USB Flash Drives and SD Cards
- Controller Settings for Synchronization and Timestamping
- Connecting a Digital Output to the Q.station 101
- Q.station X & Q.station 101 Connection Details
- Watchdog Signal and Timer Setup
- Accessing Logged Data via Windows File Explorer